AnalogX

AnalogX

89.95

Add 4 Analog channels to your CAN bus enabled data acquisition system

AnalogX is a compact and lightweight (6 grams) 4 channel Analog to CAN I/O expander, designed to be installed in-line with your wiring harness and specially designed for the harsh automotive electrical environment.

Works with any CAN enabled data system – RaceCapture, AiM, MoTeC, and even some ECUs that accept CAN data as input, like Megasquirt!

Connect almost any sensor

Connect temperature, pressure, linear,  AFR, Boost – any 0-5v sensor and broadcast it over your CAN bus at a configurable sample rate between 1 and 255Hz (default is 50Hz)

 

Quantity:
Add To Cart

Connect almost any sensor

Connect temperature, pressure, linear,  AFR, Boost – any 0-5v sensor and broadcast it over your CAN bus at a configurable sample rate between 1 and 255Hz (default is 50Hz)

Super lightweight and compact

Minimizing weight is paramount in race cars, and AnalogX adds only about 6 grams. It’s designed to install in-line with your wiring harness – no bulky harnesses or boxes to bolt down.

Automotive grade electronics

With an automotive grade power supply and fully buffered and protected inputs, it’s designed for the harsh electrical environment found in automobiles.  The ultra-high impedance inputs won’t drag down the signal it’s measuring, so you can confidently tap into existing sensors.

Run up to 4 on the same CAN bus

Jumpers on AnalogX lets you configure 4 AnalogX devices to run on the same CAN bus, for up to 16 analog inputs!

0.5 Amp 5v reference to power your sensors

AnalogX provides a 5v voltage reference with 0.5A available to power your sensors at the edge of your sensor network.

Full Documentation and simple CAN bus interface

Wiring and interfacing the CAN bus data will be a snap with your existing data system. Check out the full documentation on our wiki

Specifications

FeatureDescription

Analog input voltage range0 – 5v

DAC resolution12 bit SAR

Sample output format0 – 5000mV

Input impedanceGreater than 10 Meg Ohm

Input voltage protection100v

Pullup resistorOptional on-board 2.2K pullup resistor for each channel (jumper enabled)

Power input9 – 15volts, protected to 40v (intermittent)

Weight6 grams

Dimensions0.72″ x 1.93″ (18.3mm x 48.7mm)

CAN baud rate500K and 1M, jumper configurable

Address Space4 separate address spaces allows up to 4 AnalogX modules to operate on the same CAN network. (jumper configurable)

Parts in the Kit

In the kit you will receive:

  • AnalogX module
  • 4 wire power and CAN pigtail
  • 6 wire analog sensor input pigtail
  • 1″ shrink tube for installation