Power + CAN pigtail

Connect to an automotive CAN bus and your DC power Source with this handy cable.

This is M8 4 pin Male to flying leads 2m in length.

Used as a primary power + single CAN bus connection to enable a one cable power + data solution to the Dual CAN hub or RaceCapture. If you want to direct wire your RaceCapture Track rather than use an OBD2 connector, this is the cable for you.

M8 4P male on one end, pigtails on the other.

Power + CAN bus pigtail. Used to power CAN hub while providing a single CAN bus interface, for a single power + data connection

• M8 to tinned / prepared wires

• 2 Meter length

• Pinout:

  • Red / Pin 2: +12v

  • Black / Pin 4: Ground

  • White / Pin 1: CAN Low

  • Green / Pin 3: CAN High